Roller shutters installation Altona Tape measure, pencil, spirit level, hammer drill,  five mm, ten mm, twelve mm, 18mm, twenty two mm,  26mm  drill bit, six mm or eight mm masonry bit, screws,  hammer,  rivet gun  roller shutter installation. Some of the above apparatuses and drill bits are available in our online shop. Using a tape quantity and level, measure fifty three mm on each sideways from the adjacent of the opening. Here the guide is sitting against the wall. You can quantity from the brick side to the bottom and top of the window and draw a line between the two. This is where the outer edge of the attendant will be placed (so the line you draw will be perpendicular).

 The height of the breaker secure will depend on the size of the roller shutters installation Altona box that will fit everything on top, so it is recommended to first measure the height of the actual roller shutter box supplied before measuring the wall. Available in four sizes: 151 mm, 166mm, 181mm, and 206 mm, measure from the top edge of the window to the height of the shutter box you measured earlier. This measurement is either 151mm, 166mm, 181mm or 206mm. Mark both sides so you know where the top of the box is and draw a line between the two. Note: When drilling, make sure the dowels are always inserted into the brick and not the mortar. Then put the guide against the wall to mark the best place to drill the hole in the brick wall and attach it to the wall. You need about three places to do this.

 He then drills a six mm hole back and forth through the hollow square section of the chaperon (see image above). Note: If the open side of the guide faces the window, be aware that the curtain will hold against the glass as it moves up and down.

 Note: It’s easier to put the tool on the piece of kindling so you can drill straight through.  To mount, drill three dumps: one on top, one in the intermediate, and one on the bottommost.

 Next, drill a ten mm hole in the front of the attendant so that the screw head will fit. Screw the attendant into the wall using the pre-drilled holes.

 After removing the green elastic tabs, the outlook forelegs can be slid over the ends of the face box (these are the silver hind leg that come with the carton. Slide them over the ends of the face box to controller; make sure they are tight). Measure fifteen mm from the top of the chaperon on the side where the regulator will be placed. Portion fifteen millimetres from this argument. This will give you an access point to the controller’s twenty five mm access hole.